I've spent the last couple of weeks worth of evenings cleaning up the 3D printed parts, concentrating on the uprights. From now on I'm going to clean them parts up as I go. I don't have enough clamps to glue each section together so I'll do one a night this week while cleaning up the cross sections.
As there are no instructions labeling is a must as it helps with the assembling of this jigsaw puzzle.
As I'm using PLA to build this Droid epoxy is my glue of choice, lots of glue and clamps later.....
Many people before me have built R2D2 and other R2 units. I wanted a big 3D print project so I thought why not.
The printable R2D2 body that you see me making here was released by the wonderful Michael Baddeley over on Thingiverse.
I support Mr Baddeley on Patreon, check him out.
I'm also on Patreon and If you would like to support me you can do so here.